Products: Vineyards and Almond Groves

Material Safety Data Sheet Earthbind™ Products

Quick Identifier:	Modified Biopolymer Emulsion
Address:	2606 N. Newark St. Portland, Oregon 97217
Manufacturers Name:	EnviRoad LLC
Other Information Calls:	800-536-2650

Identity - Section I

Trade Name and Synonyms:	Earthbind™ 100, Earthbind™ Stabilizer, Earthbind™ Water Truck, Earthbind™ Prime, Earthbind™ HydroTac
CAS Number:	Mixture
Chemical Name:	NA

NFPA Hazardous Identification	Health: 1 Fire: 0 Reactivity: 0
0 - Least; 1 - Slight; 2 - Moderate; 3 - High; 4 - Extreme

Composition Information on Ingredients - Section II

Ingredients	CAS	%	OSHA PEL	ACGIH TLV
Bitumen	Proprietary	40-60	NE	NE
Stabilizer	Proprietary	5-30	NE	NE
Emulsifier	Proprietary	< 6.0	NE	NE
Water	7732-18-5	Balance	NE	NE
Additional Comments: Though further detail on contents may be confidential, all pertinent hazards are addressed in this MSDS.

Physical & Chemical Characteristics - Section III

Boiling Point	>100 C
Vapor Pressure (mm Hg)	NA
Percent Volatile by Volume	NA
Solubility in Water	Complete
Specific Gravity (H20=1.00)	1.01 to 1.05
Vapor Density (air@1)	NA
Evaporation Rate (H20 = 1)	NA
Reactivity in Water	None
Viscosity @ 77F SFS	20-450
Appearance and Odor	Dark Brown Liquid; Bitumen and molasses odor
Additional Comments	Material is a bitumen/water emulsion and will not combust until water is driven off.

Fire And Explosion Hazard Data - Section IV

Flash Point	NA
Flammable Limits in Air % by Volume	(bitumen/water emulsion)
Extinguisher Media	Dry Chemical, CO2, Halon, Water Spray, or standard foam
Fire Fighting Procedures	Move containers from fire area if possible. Cool fire-exposed containers with water from side until well after fire is out. Stay away from storage tank end for massive fire in storage area. Use unmanned hose holder or monitor. Use flooding amounts of water as a fog, as solid streams may be ineffective. Withdraw immediately in case of rising sound from venting safety device or any discoloration of storage vessel due to fire. Extinguish only if flow can be stopped. Water or foam may cause frothing. Avoid breathing toxic vapors and keep upwind.
Additional Comments	Material is a bitumen/water emulsion and will not ignite until water is driven off.

Reactivity Data - Section V

Stability/Conditions to Avoid	Material is stable under normal temperature and pressure. Do not expose to prolonged heating above 100C.
Incompatibility/Materials to Avoid	None
Hazardous Polymerization/Conditions to Avoid	None
Hazardous Byproducts of Decomposition	Thermal decomposition may release hazardous gases.

Health Hazard Data - Section VI

Route of Entry	Legend: A: Health Effect; B: Personal Protection; C: Emergency First Aid Procedures
Inhalation	Avoid prolonged inhalation of vapors or mist. Product has a low vapor pressure and is not expected to present an inhalation hazard at ambient conditions. Provide exhaust ventilation system to meet published exposure limits. Remove victim from exposure to fresh air immediately. If breathing has stopped, give artificial respiration. Keep victim warm and at rest. Treat symptomatically and supportively. Administration of oxygen should be performed by qualified personnel. Get medical attention immediately.
Skin	Direct contact with hot fumes may cause slight skin irritation. Repeated or prolonged exposure to fumes may cause irritation, dermatitis, and acne-like lesions. Employee must wear appropriate protective impervious clothing, gloves, and equipment to prevent repeated or prolonged skin contact. If contact is not with hot materials, remove contaminated clothing and shoes. Wash affected area with soap or mild detergent, and large amounts of water until no evidence of material remains. Burns from contact with hot material should be treated like thermal burns.
Ingestion	May cause nausea, gastro-intestinal irritation, and vomiting. Do not induce vomiting. Treat symptomatically and supportively. Get medical attention immediately. If vomiting occurs, lower heat to prevent aspiration.
Eyes	Contact with eyes may cause redness and irritation. Repeated or prolonged exposure to fumes may cause conjunctivitis. Employee must wear splash-proof or dust-resistant safety goggles or face shield. Wash eyes immediately with large amounts of water. Lift upper and lower lids until no evidence of material remains (15 to 20 minutes). Cover with sterile bandages. Get medical attention immediately.
Medical Conditions Aggravated by Exposure	No adverse reactions expected at concentrations normally encountered.

Safe Usage Information - Section VII

Handling, Storage & Other Precautions	This product is not classified as hazardous under DOT reg. Keep away from heat, sparks, and oxidizing agents. Keep container closed when not in use. Observe all Federal, State and Local regulations when handling, storing or disposing of this material.
Action to be Taken in Case of Spill or Release (Including Disposal)	Shut off area ignition sources. Stop leak if it can be done without risk. Use water spray to reduce vapors. For small spills, use absorbent material and place into container. Dike ahead of large spill for later disposal. Prohibit smoking in affected area. Isolate area and restrict entry.

Control Measures - Section VIII

Ventilation Requirements	Provide exhaust ventilation system to meet published exposure limits.
Work Hygiene Practices
Respirator	Selection of respiratory protection must be based upon the airborne level of suspected contaminant. Levels found in the work place must not exceed the working limit of the respirator utilized.
Dermal	Workers must wear appropriate protective clothing, gloves, and equipment to prevent repeated or prolonged contact with skin.
Eyes	Proper eye/face protection must be utilized to protect against splashes and vapors.
Carcinogenicity	The individual components of Earthbind™ are not considered to be carcininogenic.

Transportation - Section IX

D.O.T. Proper Shipping Name (49 CFR 172.101)	Non-hazardous Emulsion
D.O.T. Hazard Class (49 CFR 172.101)	NA
UN / NA Code (49 172.101)	NA
Packaging Group (49 172.101)	NA
Bill Of Lading Description (49 172.101)	Non-hazardous Emulsion
D.O.T. Labels Required (49 172.101)	NA
D.O.T. Placards Required (49 172.101)	NA

We believe the statements, technical information and recommendations contained herein are reliable, but they are given without warranty or guarantee of any kind, express or implied, and we assume no responsibility for any loss, damage, or expense, direct or consequential, arising out of their use.